diff --git a/Documentation/hwmon/index.rst b/Documentation/hwmon/index.rst index d91dbb20c7dc..b2ca8513cfcd 100644 --- a/Documentation/hwmon/index.rst +++ b/Documentation/hwmon/index.rst @@ -220,7 +220,6 @@ Hardware Monitoring Kernel Drivers q54sj108a2 qnap-mcu-hwmon raspberrypi-hwmon - sa67 sbrmi sbtsi_temp sch5627 diff --git a/Documentation/hwmon/sa67.rst b/Documentation/hwmon/sa67.rst deleted file mode 100644 index 029c7c169b7f..000000000000 --- a/Documentation/hwmon/sa67.rst +++ /dev/null @@ -1,41 +0,0 @@ -.. SPDX-License-Identifier: GPL-2.0-only - -Kernel driver sa67mcu -===================== - -Supported chips: - - * Kontron sa67mcu - - Prefix: 'sa67mcu' - - Datasheet: not available - -Authors: Michael Walle - -Description ------------ - -The sa67mcu is a board management controller which also exposes a hardware -monitoring controller. - -The controller has two voltage and one temperature sensor. The values are -hold in two 8 bit registers to form one 16 bit value. Reading the lower byte -will also capture the high byte to make the access atomic. The unit of the -volatge sensors are 1mV and the unit of the temperature sensor is 0.1degC. - -Sysfs entries -------------- - -The following attributes are supported. - -======================= ======================================================== -in0_label "VDDIN" -in0_input Measured VDDIN voltage. - -in1_label "VDD_RTC" -in1_input Measured VDD_RTC voltage. - -temp1_input MCU temperature. Roughly the board temperature. -======================= ======================================================== - diff --git a/MAINTAINERS b/MAINTAINERS index 55af015174a5..d5a2078a6717 100644 --- a/MAINTAINERS +++ b/MAINTAINERS @@ -24337,7 +24337,6 @@ F: Documentation/devicetree/bindings/interrupt-controller/kontron,sl28cpld-intc. F: Documentation/devicetree/bindings/pwm/kontron,sl28cpld-pwm.yaml F: Documentation/devicetree/bindings/watchdog/kontron,sl28cpld-wdt.yaml F: drivers/gpio/gpio-sl28cpld.c -F: drivers/hwmon/sa67mcu-hwmon.c F: drivers/hwmon/sl28cpld-hwmon.c F: drivers/irqchip/irq-sl28cpld.c F: drivers/pwm/pwm-sl28cpld.c diff --git a/drivers/hwmon/Kconfig b/drivers/hwmon/Kconfig index 41c381764c2b..486152a8ea77 100644 --- a/drivers/hwmon/Kconfig +++ b/drivers/hwmon/Kconfig @@ -1927,16 +1927,6 @@ config SENSORS_RASPBERRYPI_HWMON This driver can also be built as a module. If so, the module will be called raspberrypi-hwmon. -config SENSORS_SA67MCU - tristate "Kontron sa67mcu hardware monitoring driver" - depends on MFD_SL28CPLD || COMPILE_TEST - help - If you say yes here you get support for the voltage and temperature - monitor of the sa67 board management controller. - - This driver can also be built as a module. If so, the module - will be called sa67mcu-hwmon. - config SENSORS_SL28CPLD tristate "Kontron sl28cpld hardware monitoring driver" depends on MFD_SL28CPLD || COMPILE_TEST diff --git a/drivers/hwmon/Makefile b/drivers/hwmon/Makefile index eade8e3b1bde..5833c807c688 100644 --- a/drivers/hwmon/Makefile +++ b/drivers/hwmon/Makefile @@ -199,7 +199,6 @@ obj-$(CONFIG_SENSORS_PT5161L) += pt5161l.o obj-$(CONFIG_SENSORS_PWM_FAN) += pwm-fan.o obj-$(CONFIG_SENSORS_QNAP_MCU_HWMON) += qnap-mcu-hwmon.o obj-$(CONFIG_SENSORS_RASPBERRYPI_HWMON) += raspberrypi-hwmon.o -obj-$(CONFIG_SENSORS_SA67MCU) += sa67mcu-hwmon.o obj-$(CONFIG_SENSORS_SBTSI) += sbtsi_temp.o obj-$(CONFIG_SENSORS_SBRMI) += sbrmi.o obj-$(CONFIG_SENSORS_SCH56XX_COMMON)+= sch56xx-common.o diff --git a/drivers/hwmon/sa67mcu-hwmon.c b/drivers/hwmon/sa67mcu-hwmon.c deleted file mode 100644 index 22f703b7b256..000000000000 --- a/drivers/hwmon/sa67mcu-hwmon.c +++ /dev/null @@ -1,161 +0,0 @@ -// SPDX-License-Identifier: GPL-2.0-only -/* - * sl67mcu hardware monitoring driver - * - * Copyright 2025 Kontron Europe GmbH - */ - -#include -#include -#include -#include -#include -#include -#include -#include - -#define SA67MCU_VOLTAGE(n) (0x00 + ((n) * 2)) -#define SA67MCU_TEMP(n) (0x04 + ((n) * 2)) - -struct sa67mcu_hwmon { - struct regmap *regmap; - u32 offset; -}; - -static int sa67mcu_hwmon_read(struct device *dev, - enum hwmon_sensor_types type, u32 attr, - int channel, long *input) -{ - struct sa67mcu_hwmon *hwmon = dev_get_drvdata(dev); - unsigned int offset; - u8 reg[2]; - int ret; - - switch (type) { - case hwmon_in: - switch (attr) { - case hwmon_in_input: - offset = hwmon->offset + SA67MCU_VOLTAGE(channel); - break; - default: - return -EOPNOTSUPP; - } - break; - case hwmon_temp: - switch (attr) { - case hwmon_temp_input: - offset = hwmon->offset + SA67MCU_TEMP(channel); - break; - default: - return -EOPNOTSUPP; - } - break; - default: - return -EOPNOTSUPP; - } - - /* Reading the low byte will capture the value */ - ret = regmap_bulk_read(hwmon->regmap, offset, reg, ARRAY_SIZE(reg)); - if (ret) - return ret; - - *input = reg[1] << 8 | reg[0]; - - /* Temperatures are s16 and in 0.1degC steps. */ - if (type == hwmon_temp) - *input = sign_extend32(*input, 15) * 100; - - return 0; -} - -static const struct hwmon_channel_info * const sa67mcu_hwmon_info[] = { - HWMON_CHANNEL_INFO(in, - HWMON_I_INPUT | HWMON_I_LABEL, - HWMON_I_INPUT | HWMON_I_LABEL), - HWMON_CHANNEL_INFO(temp, HWMON_T_INPUT), - NULL -}; - -static const char *const sa67mcu_hwmon_in_labels[] = { - "VDDIN", - "VDD_RTC", -}; - -static int sa67mcu_hwmon_read_string(struct device *dev, - enum hwmon_sensor_types type, u32 attr, - int channel, const char **str) -{ - switch (type) { - case hwmon_in: - switch (attr) { - case hwmon_in_label: - *str = sa67mcu_hwmon_in_labels[channel]; - return 0; - default: - return -EOPNOTSUPP; - } - default: - return -EOPNOTSUPP; - } -} - -static const struct hwmon_ops sa67mcu_hwmon_ops = { - .visible = 0444, - .read = sa67mcu_hwmon_read, - .read_string = sa67mcu_hwmon_read_string, -}; - -static const struct hwmon_chip_info sa67mcu_hwmon_chip_info = { - .ops = &sa67mcu_hwmon_ops, - .info = sa67mcu_hwmon_info, -}; - -static int sa67mcu_hwmon_probe(struct platform_device *pdev) -{ - struct sa67mcu_hwmon *hwmon; - struct device *hwmon_dev; - int ret; - - if (!pdev->dev.parent) - return -ENODEV; - - hwmon = devm_kzalloc(&pdev->dev, sizeof(*hwmon), GFP_KERNEL); - if (!hwmon) - return -ENOMEM; - - hwmon->regmap = dev_get_regmap(pdev->dev.parent, NULL); - if (!hwmon->regmap) - return -ENODEV; - - ret = device_property_read_u32(&pdev->dev, "reg", &hwmon->offset); - if (ret) - return -EINVAL; - - hwmon_dev = devm_hwmon_device_register_with_info(&pdev->dev, - "sa67mcu_hwmon", hwmon, - &sa67mcu_hwmon_chip_info, - NULL); - if (IS_ERR(hwmon_dev)) - dev_err(&pdev->dev, "failed to register as hwmon device"); - - return PTR_ERR_OR_ZERO(hwmon_dev); -} - -static const struct of_device_id sa67mcu_hwmon_of_match[] = { - { .compatible = "kontron,sa67mcu-hwmon", }, - {} -}; -MODULE_DEVICE_TABLE(of, sa67mcu_hwmon_of_match); - -static struct platform_driver sa67mcu_hwmon_driver = { - .probe = sa67mcu_hwmon_probe, - .driver = { - .name = "sa67mcu-hwmon", - .of_match_table = sa67mcu_hwmon_of_match, - }, -}; -module_platform_driver(sa67mcu_hwmon_driver); - -MODULE_DESCRIPTION("sa67mcu Hardware Monitoring Driver"); -MODULE_AUTHOR("Michael Walle "); -MODULE_LICENSE("GPL");